| Common Mode Impedance (Zc) | Meet item 3. | Measuring Equipment : KEYSIGHT4291A or the equivalent Measuring Frequency : 1001MHz |
| Withstanding Voltage | Products shall not be damaged. | Test Voltage : 2.5 times for Rated Voltage Time : 1 to 5 seconds Charge Current : 1 mA max. |
| DC Resistance (Rdc) | Meet item 3. | Measuring current : 100mA max. |
| Insulation Resistance (I.R.) | | Measuring voltage : Rated Voltage Measuring time : 1 minute max. |
| Appearance and Dimensions | Meet item 5. | Visual Inspection and measured with Slide Calipers. |
| Bonding Strength | No evidence of coming off substrate. Products shall not be mechanical damaged. It shall be soldered on the substrate. | Applying Force(F) : 5N Applying Time : 51seconds |
| Bending Strength | Meet Table 1. | Deflection : 2mm (t=1.0mm) Keeping time : 5 seconds Speed of Applying Force : 0.5mm/s |
| Drop | | Method : free fall Height : 1 m The Number of Times : 3 times |
| Vibration | It shall be soldered on the substrate. | Oscillation Frequency : 10 to 55 to 10Hz for 1 minute Total Amplitude : 1.5mm Testing Time : A period of 2 hours in each of 3 mutually perpendicular directions. (Total 6 hours) |
| Solderability | The electrodes shall be at least 90% covered with new solder coating. | Flux:Ethanol solution of rosin,25(wt)% includes activator equivalent to 0.06 to 0.10(wt)% chlorine Pre-Heating : 80 to 120C 1minute Solder : Sn-3.0Ag-0.5Cu Solder Temperature : 2453C Immersion Time : 41 seconds Immersion and emersion rates : 25mm/s |
| Resistance to Soldering Heat | Meet Table 1. | Flux : Ethanol solution of rosin,25(wt)% includes activator equipment to 0.06 to 0.10(wt)% chlorine Pre-Heating : 80 to 120C, 1minute Solder : Sn-3.0Ag-0.5Cu Solder Temperature : 2605C Immersion Time : 50.5 seconds Immersion and emersion rates : 25mm/s Then measured after exposure in the room condition for 4 to 48 hours. |
| Temperature Cycle | Meet Table 1. | 1 Cycle Step 1 -40C(+0C,-3C) / 303 min Step 2 Ordinary Temp. / 10 to 15 minutes Step 3 +85C(+3C,-0C) / 303 min Step 4 Ordinary Temp. / 10 to 15 minutes Total of 10 cycles Then measured after exposure in the room condition for 4 to 48 hours |
| Humidity | | Temperature : 402C Humidity : 90~95%(RH) Time : 1000(+48 hours,-0 hours) Then measured after exposure in the room condition for 4 to 48 hours. |
| Heat life | | Temperature : 852C Applying Voltage : 2times for Rated Voltage Time : 1000(+48 hours,-0 hours) Then measured after exposure in the room condition for 4 to 48 hours. |
| Cold Resistance | | Temperature : -40 2C Time : 1000(+48 hours,-0 hours) Then measured after exposure in the room condition for 4 to 48 hours. |
